Administration Commands
query_rtp_connection
dest_node_name
Fully qualified name of the destination control point for the RTP portion of the session.
cos_name
Name of the class of service used by the RTP connection.
num_sess_active
Number of sessions active on this RTP connection.
arb_mode
Specifies the ARB mode in use on this RTP Connection. Possible values are:
ARB_S
Standard mode ARB.
ARB_R
Responsive mode ARB.
UNKNOWN
The ARB mode has not yet been determined because the RTP connection is not yet established.
connection_type
Specifies the type of sessions on the RTP connection. Possible values are:
RTP_CP_CP_SESSION
The RTP connection carries
RTP_LU_LU_SESSION
The RTP connection carries
RTP_ROUTE_SETUP
The RTP connection is used for route setup.
max_btu_size
Maximum size, in bytes, of the basic transmission unit (BTU) used on the RTP connection.
liveness_timer
Liveness timer, measured in seconds, for the RTP connection. If no traffic flows on a connection during a liveness timer interval, RTP starts a status exchange to check if its partner is still there. A short liveness timer interval provides quick detection of line failures and rapid path switching when a line fails. However, if the interval is too short, performance is slightly degraded by the frequent checks on the status of the line.
local_tcid
Local TCID (transport control identifier) for the RTP connection.
remote_tcid
Remote TCID for the RTP connection.
bytes_sent
Total number of bytes that the local node has sent on this RTP connection.
bytes_received
Total number of bytes that the local node has received on this RTP connection.
bytes_resent
Total number of bytes that the local node has resent on this RTP connection because bytes were lost in transit.
524
