Administration Commands
delete_internal_pu
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_CATEGORY_NAME
The ms_category parameter contained a character that was not valid.
INVALID_TYPE
The type parameter was not set to a valid value.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node does not support MS network management functions; support is defined by the mds_supported parameter in the node definition.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.75 delete_internal_pu
The delete_internal_pu command deletes a
2.75.1 Supplied Parameters
Parameter name | Type | Length |
[delete_internal_pu] |
|
|
pu_name | character | 8 |
The supplied parameter is:
pu_name
Name of the internal PU to be deleted. This name is a
2.75.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
264
