HP UX Internet and Networking Software manual Hprsupported

Administration Commands

define_sdlc_ls

To specify the global backup default DLUS defined using define_dlur_defaults, do not specify this parameter.

hpr_supported

Specifies whether HPR is supported on this link. This parameter must be set to NO unless the adj_cp_type parameter indicates that the link connects to an APPN node. Possible values are:

YES

HPR is supported on this link.

NO

HPR is not supported on this link.

link_deact_timer

Limited resource link deactivation timer, in seconds. A limited resource link is automatically deactivated if no data flows over the link for the time specified by this parameter. This parameter is not used if limited_resource is set to any value other than INACTIVITY.

The minimum value is 5; values in the range 1–4will be interpreted as 5.

The value 0 (zero) indicates one of the following:

•If the hpr_supported parameter is set to YES, the default deactivation timer value of 30 is used.

•If the hpr_supported parameter is set to NO, no timeout is used (the link is not deactivated, as if limited_resource were set to NO).

default_nn_server

For an end node this parameter specifies whether the link station being defined supports CP-CP sessions to a network node that can act as the local node’s network node server. When the local node has no CP-CP sessions to a network node server and needs to establish them, the local node checks this parameter on its defined link stations to find a suitable LS to activate. This enables you to specify which adjacent NNs are suitable to act as the NN server (for example, to avoid using NNs that are accessed by expensive or slow links).

Possible values are:

YES

This link supports CP-CP sessions to a network node that can act as the local node’s NN server; the local node can automatically activate this link if it needs to contact an NN server. The cp_cp_sess_support parameter must be set to YES.

NO

This link does not support CP-CP sessions to a network node that can act as the local node’s NN server; the local node cannot automatically activate this link if it needs to contact an NN server.

If the local node is not an end node, this parameter is ignored.

ls_attributes

Attributes of the remote system with which SNAplus2 is communicating.

Specify SNA unless you are communicating with a host of one of the other following types. Possible values are:

SNA

Standard SNA host

FNA

Fujitsu Network Architecture (VTAM-F) host

187