Administration Commands
define_node
INVALID_MIN_CONWINNERS
The min_conwin_src parameter was not in the valid range, or was greater than plu_mode_session_limit.
INVALID_MIN_CONTENTION_SUM
The sum of the min_conloser_src and min_conwin_src parameters exceeded the value of plu_mode_session_limit.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.42 define_node
The define_node command defines a new node, or modifies an existing node. It must be issued to a server where the node is not running; it cannot be issued to a running node.
When using the
There is no equivalent command to delete a node. If you want to remove the entire configuration of the node and create a completely new configuration, stop the node, and then delete or rename the node’s configuration file. Next, issue a new define_node command to the inactive node to create a new node configuration file.
2.42.1 Supplied Parameters
Parameter name | Type | Length | Default |
[define_node] |
|
|
|
node_name | character | 128 | (null string) |
description | character | 31 | (null string) |
node_type | constant |
| END_NODE |
fqcp_name | character | 17 |
|
cp_alias | character | 8 |
|
mode_to_cos_map_supp | constant |
| YES |
mds_supported | constant |
| YES |
node_id | hex array | 4 | 0x05DFFFFF |
max_locates | decimal |
| 1500 |
dir_cache_size | decimal |
| 255 |
max_dir_entries | decimal |
| 0 |
locate_timeout | decimal |
| 0 |
reg_with_nn | constant |
| YES |
reg_with_cds | constant |
| YES |
mds_send_alert_q_size | decimal |
| 100 |
cos_cache_size | decimal |
| 24 |
tree_cache_size | decimal |
| 40 |
tree_cache_use_limit | decimal |
| 40 |
max_tdm_nodes | decimal |
| 0 |
max_tdm_tgs | decimal |
| 0 |
max_isr_sessions | decimal |
| 1000 |
isr_sessions_upper_threshold | decimal |
| 900 |
138
