Administration Commands

define_ip_dlc

udp_port_low

UDP port number used for low priority traffic.

ip_precedence_llc

IP precedence value used for LLC commands, in the range 0 (minimum)—7(maximum).

ip_precedence_network

IP precedence value used for network priority traffic, in the range 0 (minimum)—7(maximum).

ip_precedence_high

IP precedence value used for high priority traffic, in the range 0 (minimum)—7(maximum).

ip_precedence_medium

IP precedence value used for medium priority traffic, in the range 0 (minimum)—7(maximum).

ip_precedence_low

IP precedence value used for low priority traffic, in the range 0 (minimum)—7(maximum).

no_dns_lookup

Specifies whether remote host IP addresses are specified as IPv4 dotted-decimal addresses or as names requiring lookup at a Domain Name Server. Possible values are:

YES

The remote host IP address on each link station defined for this DLC is specified as a dotted-decimal IP address (such as 193.1.11.100). The DLC does not need to perform any Domain Name Server lookup for incoming or outgoing calls.

NO

The remote host IP address on link stations defined for this DLC can be specified as a dotted-decimal IP address (such as 193.1.11.100), as a name (such as newbox.this.co.uk), or as an alias (such as newbox). The node performs a Domain Name Server lookup to determine the remote host name on all incoming calls, and on outgoing calls for link stations where the remote host IP address is specified as a name or alias.

2.31.2 Returned Parameters

No parameters are returned by SNAplus2 when this command executes successfully.

2.31.3 Error Return Codes

If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.

Parameter Check

If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:

primary_rc

PARAMETER_CHECK

secondary_rc

INVALID_DLC_NAME

The supplied dlc_name parameter contained a character that was not valid.

100

Page 100
Image 100
HP UX Internet and Networking Software Udpportlow, Ipprecedencellc, Ipprecedencenetwork, Ipprecedencehigh, Ipprecedencelow