Administration Commands
delete_lu_0_to_3
INVALID_LOCAL_LU
The lu_name parameter contained a character that was not valid.
INVALID_PARTNER_LU
The fq_partner_lu parameter contained a character that was not valid.
INVALID_WILDCARD_NAME
The wildcard_fqplu parameter was set to YES, but the fq_partner_lu parameter was not a valid wildcard name.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
INVALID_LOCAL_LU
The lu_name parameter did not match an existing LS routing record.
INVALID_PARTNER_LU
The fq_partner_lu parameter did not match an existing LS routing record for the specified local LU.
INVALID_WILDCARD_NAME
The wildcard_fqplu parameter was set to YES, but no matching entry was found.
INVALID_RESOURCE_NAME
No LS routing entry that matched the supplied parameters was found.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.79 delete_lu_0_to_3
The delete_lu_0_to_3 command is used to delete an LU used for 3270 emulation, RJE or LUA (an LU of type 0, 1, 2, or 3).
2.79.1 Supplied Parameters
Parameter name | Type | Length |
[delete_lu_0_to_3] |
|
|
lu_name | character | 8 |
Supplied parameter is:
lu_name
Name of the local LU to be deleted. This name is a
2.79.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
269
