Polycom 1500/1800/2000/4000 manual Manually Adding Flags to the Csmoduleparameters Tab

System Configuration Flags

Manually Added, Modified, Deleted System Flags

Flag	Description
VSW_HD_720p50_60_HP_THRES	Controls the Minimum Threshold Line Rate (kbps) for HD720p50 and
HOLD_BITRATE	HD720p50 resolutions for High Profile-enabled VSW conferences.
	Default: 832
VSW_RATE_TOLERANCE_PEREC	Determines the percentage of bandwidth that can be deducted from the
ENT	required bandwidth to allow participants to connect to the conference.
	For example, a value of 20 will allow a participant to connect to the
	conference if the allocated line rate is up to 20% lower than the conference
	line rate (or between 80% to 100% of the required bandwidth).
	Range: 0 - 75
	Default: 0
VSW_SD_HP_THRESHOLD_BITR	Controls the Minimum Threshold Line Rate (kbps) for SD resolution for
ATE	High Profile-enabled VSW conferences.
	Default: 128
WRONG_NUMBER_DIAL_RETRIE	The number of re-dial attempts for a wrong destination number or a wrong
S	destination number time-out.
	Range: 0 - 5
	Default: 3
	A flag value of 0 means that no redials are attempted.

Manually Adding Flags to the CS_MODULE_PARAMETERS Tab

Using the procedure to manually add flags to the System Configuration, the following flags can be manually added to the CS_MODULE_PARAMETERS tab:

Manually Added CS_MODULE_PARAMETERS System Flags

Flag	Description
CS_ENABLE_EPC	Add this flag with the value YES (default value is NO) to enable endpoints that support
	People+Content and require a different signaling (for example, FX endpoints) to receive
	Content.
H245_TUNNELING	For use in the Avaya Environment.
	In the Avaya Environment, set the flag to YES to ensure that H.245 is tunneled through
	H.225. Both H.245 and H.225 will use the same signaling port.
	Default: NO.
H323_RAS_IPV6	If the Collaboration Server is configured for IPv4 & IPv6 addressing, RAS (Registration,
	Admission, and Status) messages are sent in both IPv4 and IPv6 format. If the
	gatekeeper cannot operate in IPv6 addressing mode, registration fails and endpoints
	cannot connect using the Collaboration Server prefix.
	In such cases this System Flag should be set to NO.
	Default: YES

Polycom®, Inc. 803