Brocade Communications Systems IP250 user manual HMACMD5

Individual IP device discovery 3

NOTE

You can configure both SNMPv3 and SNMPv1/SNMPv2c credentials at the same time; however, discovery tries the SNMPv3 credentials before trying the SNMPv1 and SNMPv2c credentials.

5.Configure the SNMPv3 read-write credentials by completing the following steps.

NOTE

These credentials are not applicable for DCB devices. a. Click the SNMPv3 Read/Write tab.

FIGURE 36 SNMPv3 credentials

b.Enter the SNMPv3 user name in the User ID field.

The user name can be from 1 through 16 characters long, case sensitive, and allows all printable ASCII characters.

c.Select one of the following protocols from the Authentication Protocol list:

•None

•HMAC_MD5

•HMAC_SHA

d.Enter the SNMPv3 authentication password in the Authentication Password field.

The password can be from 8 through 16 characters long, case sensitive, and allows all printable ASCII characters. The password display as asterisks.

e.Select one of the following protocols from the Privacy Protocol list:

•None

•CBC-DES

•CFB_AES-128

If you select a privacy protocol, the selected protocol encrypts the SNMP request and response packets.

f.Enter the privacy password in the Privacy Password field.

The password can be from 1 through 16 characters long, case sensitive, and allows all printable ASCII characters. The password display as asterisks.

6.Configure the SNMPv3 read only credentials by completing the following steps.

Brocade Network Advisor IP User Manual	85
53-1003056-01