Brocade Communications Systems IP250 user manual Vpls settings, Endpoint settings PE Devices

VPLS Manager 28

3.To specify new filter criteria, select By Name or By VCID from the VPLS list. You can use the following to filter the VPLS instances:

•Asterisk (*) as a wildcard character if you select By Name.

•Individual VCIDs or a range of VCIDs, separating each entry with a comma if you selected By VCID.

4.Click Get to begin the search.

Information about products that match the search criteria displays under VPLS Settings, PE Products, and Endpoints on the Details tab.

VPLS settings

- VCID of the VPLS - Name of the VPLS

- Current status of the VPLS. This status is derived from the state of all PE devices for a VPLS.

Endpoint settings - PE Devices

PE Devices: Name and IP address of the PE device on which the VPLS is configured.

Peer up: Shows the number of peers that are up.

Endpoint up: Shows the number of endpoints that are up.

-Endpoints

Endpoint: Names and IP addresses of the endpoint devices.

Tag Mode: Tagged if a VLAN tag is used. Untagged if a VLAN tag is not used.

Outer VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The service provider end point tag.

Inner VLAN ID - Present if the Tag Mode for the endpoint is Tagged. The customer end point tag.

L2 Status: Layer 2 status - Up or Down.

5.To view VPLS peer topologies, select the Peer Topology tab. A topology map displays (Figure 361).

Brocade Network Advisor IP User Manual	885
53-1003056-01