Brocade Communications Systems IP250 user manual Configuring L3 ACL advanced settings

18 Layer 3 access control list policy

Configuring L3 ACL advanced settings

You configure L3 ACL advanced settings for extended L3 ACL device configurations. To configure an extended L3 ACL, refer to one of the following procedures:

•“Creating an extended L3 ACL configuration” on page 585

•“Editing an extended L3 ACL configuration” on page 587

•“Copying an extended L3 ACL configuration” on page 588

•“Creating an IPv6 L3 ACL configuration” on page 590

•“Editing an IPv6 L3 ACL configuration” on page 592

•“Copying an IPv6 L3 ACL configuration” on page 593

To configure advanced settings for an extended L3 ACL configuration, complete the following steps.

1.Click Advanced Settings on the Add/Edit/Duplicate - L3 ACL Configuration dialog box.

FIGURE 222 Advanced Settings dialog box

2.(IPv4 ACL only) Select one of the following types of service (TOS) to use to filter the packet from the Type of Service list.

•None — Select to not filter by TOS.

•Normal — Select to filter packets that match the normal TOS. The decimal value is 0.

•Other — Select filter by one or more additional options.

3.(IPv4 ACL only) If you selected Other from the Type of Service list, select one or more of following additional options:

•Min-monetary cost (1) — Select to have the ACL filter packets that match the minimum monetary cost TOS. The decimal value is 1.

•Max-reliability (2) — Select to have the ACL filter packets that match the maximum reliability TOS. The decimal is 2.

598	Brocade Network Advisor IP User Manual
	53-1003056-01