Brocade Communications Systems IP250 user manual Selecting a report, Report list

IP Traffic analyzer monitoring and sFlow reports 33

4.To launch the sFlow Configuration wizard and configure an sFlow data collector, select Configure sFlow.

Selecting a report

Use the report header to configure the report display. This section explains the available fields and selection options.

Report list

Select the type of traffic that you want to view from the list.

•For Layer 2 reports, select MAC, VM, or VLAN.

•For L3/L4 reports, select IPv4, IPv6, IPX, AppleTalk (AT), VM, or Others.

•For TCP reports, select Invalid TCP Flags or Valid TCP Flags.

•For Misc. reports, select BGP Paths.

When you select IPv4 or IPv6 from the Report list, another list appears. From this additional list, select the Layer 4 protocol to be included in the report. You can select All, TCP, UDP, ICMP, or Other, which includes all protocols excluding TCP, UDP, and ICMP.

Direction list

This is only available for VM Reports. Select one of the following from the list:

•Source

•Destination

•Both

Graph list

If the Graph box is enabled, select the format of the graph to be used to display the report. You can choose, Bar, Line, or Pie.

End Date/Time list

Select the date and time when the report is to end from the lists.

Span list

Span is the amount of data you want to include in the report. Select 1, 2, 4, 6, or 12 hours or 1 day (24 hours) from the list.

How End Date/Time and Span works:

Assume you have seven days of sFlow data from June 1 through 7. You want to view the first four hours of data during June 2. From the End Date/Time lists, select 6/2 for day and 4 am for time. In the Span list, select 4h. The resulting report shows four hours of data for June 2, beginning at 12 am and ending at 4 am.

Brocade Network Advisor IP User Manual	1039
53-1003056-01