Brocade Communications Systems IP250 Viewing the MEPs in a maintenance association, 802.1ag CFM

28 802.1ag Connectivity Fault Management

Viewing the MEPs in a maintenance association

You can access 802.1ag CFM from the following features:

•VPLS Manager (requires the IP - MPLS – VLL prvilege with read-write or read-only permission)

•VLL Manager (requires the IP - MPLS – VPLS prvilege with read-write or read-only permission)

•VLAN Manager (requires the VLAN Manager prvilege with read-write or read-only permission)

NOTE

802.1ag CFM is only supported on IronWare Ethernet Routers devices running firmware release 5.2 or later.

NOTE

You cannot configure an 802.1ag CFM on a maintenance end point (MEP) configured with dual tagged VLANs.

To view the MEPs in a maintenance association, complete the following steps.

1.Choose one of the following options:

-From the VPLS Manager dialog box, Views tab, choose one of the following options:

•Select a device from the VPLS Peer Status/VPLS Name/VCID list and click 802.1ag CFM.

•Select the Peer Topology tab and right-click a device in the topology and select

802.1ag CFM.

-From the VLL Manager dialog box, Views tab, select an instance from the VLL Instances table and click 802.1ag CFM.

-From the VLAN Manager dialog box - VLAN View or Product View, select a VLAN from list and click 802.1ag CFM.

The Configure 802.1ag CFM dialog box displays.

2.Select the maintenance association in the Maintenance Association Details list.

The MEPs associated with the maintenance association display in the Maintenance End Points (MEP) table:

•The product on which the MEP is located

•The VLAN ID of the MEP

•The port of the MEP

•The user-defined end-point identifier of the MEP

•The direction (up or down) of the MEP

3.Use the dialog box to perform any of the following tasks:

•To add a MEP to a maintenance association, refer to “Adding a MEP to a maintenance association” on page 904.

•To edit a MEP, refer to “Editing a MEP” on page 906.

•To delete a MEP to a maintenance association, refer to “Deleting a maintenance association” on page 909.

•To check the status of all remote MEPs for the selected MEP, refer to “Checking the connectivity status of remote MEPs” on page 910.

908	Brocade Network Advisor IP User Manual
	53-1003056-01