Brocade Communications Systems IP250 user manual Testing a configuration

Testing a configuration 25

•Click Deploy to deploy the configuration to the selected targets. Click Yes on the confirmation message.

If you selected the Prompt for additional targets during manual deployment check box, the Target tab of the Deployment of Configuration_Name dialog box displays. Continue with step 6.

If the configuration contains parameters that must be defined, the Deployment of Configuration_Name dialog box displays with a list of all parameters in the deployment. Go to step 7.

6.Define additional targets for the deployment (refer to step 4), as needed.

7.Edit the mode and the parameter values (refer to step 6), as needed.

8.Click OK.

The Deployment Status dialog box displays, which allows you to view the progress and status of the deployment.

Click Abort to stop the deployment.

NOTE

The abort action does not stop the tasks that have already started.

When deployment is complete, click Report to view the CLI Deployments Report.

9.Click Close to close the Deployment Status dialog box.

NOTE

Closing the Deployment Status dialog box does not stop deployment.

To check the results of the deployment in the Product CLI Report, refer to “CLI deployment reports” on page 802. For details about valid and invalid responses when you deploy a configuration, refer to “Valid and invalid responses from devices” on page 790.

Testing a configuration

To test a configuration, complete the following steps.

1.Select Configure > CLI Configuration. The CLI Configuration dialog box displays.

2.Select the configuration you want to verify in the Templates table and click Verify.

3.Click Yes on the “Do you want to verify?” message to confirm.

If you selected the Prompt for additional targets during manual deployment check box, the Target tab of the Deployment of Configuration_Name dialog box displays. Continue with step 4.

If the configuration contains parameters that must be defined, the Deployment of Configuration_Name dialog box displays with a list of all parameters in the deployment. Go to step 5.

4.Define additional targets for the deployment (refer to step 4), as needed.

Brocade Network Advisor IP User Manual	789
53-1003056-01