Brocade Communications Systems IP250 user manual 572 53-1003056-01

18 Layer 2 access control list management

FIGURE 210 Device_Name - Layer 2 ACL Configuration (Extended) dialog box

4.Enter a name for the ACL in the Name field.

5.Enter a sequence number for the ACL in the Sequence field.

6.Select Permit or Deny from the Action list.

7.In the Source list, select one of the following options:

•Any

•Host

•MAC

Selecting MAC or Host enables the Source field. Enter the source address on which the configuration filters traffic in the Source field.

8.In the Destination Address list, select one of the following options:

•Any

•Host

•MAC

Selecting MAC or Host enables the Destination field. Enter the destination address on which the configuration filters traffic in the Destination field.

9.Select the Count check box to enable counting.

Count specifies the number of packets filtered (allowed or denied) for the ACL rule.

10.Select the Ether Type check box to specify the Ethernet protocol.

11.In the Ether Type list, select one of the following to specify the Ethernet type being transferred in the Ethernet frame:

•ARP — Address Resolution Protocol

•FCoE — Fibre Channel over Ethernet

•IPV4- — Internet Protocol, version 4

•Custom — Enter a custom protocol. Valid values are 1536 through 65535.

12.Click the right arrow button.

572	Brocade Network Advisor IP User Manual
	53-1003056-01