Brocade Communications Systems IP250 user manual Editing a network

18 Layer 3 access control list policy

3.Enter a name for the network in the Name field.

4.Enter a valid IP address (IPv4 format) in the Subnet field.

5.Enter a valid IP address in the Mask field.

If you use the ACL Network as the source IP address, the Subnet mask from the ACL Network will be converted to Wildcard mask when deploying the ACL to the device.

The Network dialog box only accepts subnet mask.

6.Click OK on the Add Network dialog box.

7.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

Editing a network

You can access the Network dialog box when configuring a standard or extended L3 ACL device configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

•“Creating a standard L3 ACL configuration” on page 581

•“Editing a standard L3 ACL configuration” on page 584

•“Copying a standard L3 ACL configuration” on page 585

•“Creating an extended L3 ACL configuration” on page 585

•“Editing an extended L3 ACL configuration” on page 587

To edit a network, complete the following steps.

1.Click the Networks tab.

2.Select the network you want to edit in the List of Networks table and click Edit. The Edit Network dialog box displays.

3.Enter a valid IP address (IPv4 format) in the Subnet field.

4.Enter a valid IP address in the Mask field.

5.Click OK on the Edit Network dialog box.

6.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

604	Brocade Network Advisor IP User Manual
	53-1003056-01