Layer 3 access control list policy

18

Deleting a network group

NOTE

You cannot delete a network group that is in use.

You can access the Network dialog box when configuring a standard or extended L3 ACL device configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

“Creating a standard L3 ACL configuration” on page 581

“Editing a standard L3 ACL configuration” on page 584

“Copying a standard L3 ACL configuration” on page 585

“Creating an extended L3 ACL configuration” on page 585

“Editing an extended L3 ACL configuration” on page 587

“Copying an extended L3 ACL configuration” on page 588

To delete a network group, complete the following steps.

1.Click the Network Groups tab.

2.Select one or more network groups that you want to delete in the List of Network Groups table and click Delete.

3.Click Yes on the confirmation message.

4.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

Service configuration

The Management application allows you to filter traffic from a specific service source or destination port. A service is either TCP or UDP port. Use the following procedures to configure a service:

“Viewing existing services” on page 612

“Creating a service” on page 613

“Editing a service” on page 614

“Copying a service” on page 614

“Deleting a service” on page 615

Brocade Network Advisor IP User Manual

611

53-1003056-01

 

Page 663
Image 663
Brocade Communications Systems IP250 user manual Service configuration, Deleting a network group