Brocade Communications Systems IP250 user manual Management Module switchover, Enable or Disable

22 Management Module switchover

A warning message displays:

You want to reset the selected interface statistics. Do you want to continue?

Click Yes to clear all the statistics of the port.

FIGURE 274 Resetting port counters

Enable or Disable

Enable or disable on a module will perform module power on or off. It is applicable only to the configuration module.

To enable or disable a port, right-click a slot (or slots), trunk (or trunks), or port (or ports) and select Enable or Disable.

NOTE

After performing the enable or disable operation on ports or at module level, the changes will be reflected only after the discovery of the product.

Management Module switchover

The Management Module allows you to manage all of the routing actions of a device. If there is more than one Management Module you can make one of the modules the active module and the other module the standby module.

NOTE

If the active Management Module fails, you must switch to the the standby module.

Changing the standby Management Module to active

To change the standby Management Module to active, click Configure > MR Switch Over (as shown in Figure 275).

Or

736	Brocade Network Advisor IP User Manual
	53-1003056-01