Brocade Communications Systems IP250 Click OK on the Add L3 ACL IPv 6 Configuration dialog box

Layer 3 access control list policy 18

•To enter an IP address, select IP Address and complete the following steps:

a.Enter the destination IP address on which the ACL filters traffic in the IP Address list and text field.

You can enter the IPv6 address in compressed (for example, you can compress 2001:db8:0:0:0:0:2:1 can be shortened to 2001:db8::2:1) or raw format.

b.Enter the prefix length (1 through 128) in the Prefix Length field.

•To select a network, select IP Address and choose a network from the list.

•To enter a host name, select Host and enter the destination host name on which the ACL filters traffic in the Host list and text field.

8.Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.

9.Select the Log Enable check box to enable logging.

10.Click Advanced Settings to configure additional settings for the ACL configuration.

NOTE

You must configure advanced settings to create an extended Layer 3 ACL. The L3 ACL Advanced Settings dialog box displays.

FIGURE 219 Add - L3 Advanced Settings dialog box (IPv6)

To configure additional settings, refer to “Configuring L3 ACL advanced settings” on page 598.

11.Click the right arrow button.

The new ACL displays in the ACL Entries list.

12.Repeat step 4 through step 11 to add additional entries.

13.Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.

14.View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking View.

The L3 ACL Advanced Settings dialog box displays.

15.Click Close on the L3 ACL Advanced Settings dialog box to close.

16.Click OK on the Add - L3 ACL (IPv 6) Configuration dialog box.

Brocade Network Advisor IP User Manual	591
53-1003056-01