Brocade Communications Systems IP250 Creating a DCB map, Off, Priority group ID, 15.0-15.7

16 QoS configuration
	TABLE 54	Priority grouping allocated in a 15-priority group example
	Priority group ID		Bandwidth (%)	Priority flow control
		0	55	on
		1	25	on
		2	0	off
		3	0	off
		4	5	off
		5	0	off
		6	15	on
		7	0	off
15.0-15.7			Strict priority	on
			No bandwidth % configuration
			allowed

Creating a DCB map

The procedure in this section applies only for Fabric OS versions earlier than Fabric OS 7.0.

When you create a DCB map, each of the Class of Service (CoS) options (0-7) must be mapped to at least one of the Priority Group IDs (0-7) and the total bandwidth percentage must equal 100. All QoS, DCB map, and Traffic Class map configurations apply to all ports in a LAG.

There can be, at the most, 16 entries in the Priority Group table. Eight of the entries are Strict Priority entries with a Priority Group ID (15.0-15.7) and eight are user-definable entries with a Priority Group ID of 0-7. Refer to Table 54 for an example of priority group configuration.

NOTE

The 10 Gbps DCB/FC switch module can have only one DCB map.

1.Select Configure > DCB.

The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and functions.

2.Select a switch, and click Edit.

3.Click the QoS tab on the Edit Switch dialog box.

The QoS dialog box displays, as shown in Figure 188.

502	Brocade Network Advisor IP User Manual
	53-1003056-01