Brocade Communications Systems IP250 Viewing Layer 2 ACL configuration on an interface Network OS

Layer 2 access control list management 18

FIGURE 213 Device_Name - Layer 2 ACL Configuration dialog box

2.Review the Layer 2 ACL configuration details.

•ACLs list — Displays the ACLs to be deployed for this configuration. The ACLs list includes the following details:

Operation — Displays the ACL operation (no action) during deployment.

Name — The name of the ACL.

Type — The ACL type. Options include: Extended or Standard.

•Details of Selected ACLs list — Displays the details of the ACL selected in the ACLs list. The Details of Selected ACLs table includes the following details:

Sequence — The Layer 2 ACL entry sequence number.

Action — Whether the ACL permits or denies traffic.

Source — The source MAC address on which the ACL filters traffic.

Destination (Extended only) — The destination MAC address on which the ACL filters the traffic.

Count — Whether count is enabled or disabled.

Ether Type (Extended only) — The Ethernet protocol. Values include ARP, FCoE, IPv4, or Custom.

•Add button — Displays; however, is not available.

•Edit button — Displays; however, is not available.

•Duplicate button — Displays; however, is not available.

•Delete button — Displays; however, is not available.

3.Click OK to close on the Device_Name - Layer 2 ACL Configuration dialog box.

Viewing Layer 2 ACL configuration on an interface (Network OS)

NOTE

You cannot configure a Layer 2 ACL using the Management application. You must configure the Layer 2 ACL through the Network OS CLI (refer to the Network OS Command Reference).

To view Layer 2 ACL configurations on an interface, complete the following steps.

Brocade Network Advisor IP User Manual	579
53-1003056-01