Brocade Communications Systems IP250 user manual Configuration, Native VLAN/VLAN

E	IP device properties
		Field/Component	Description
		Configuration	Displays one of the following VLAN configuration options:
			• Access mode — Supports MAC address and MAC group
			•	classification.
				Trunk mode
				•	Add — Adds VLAN IDs to the port profiles.
				•	Remove — Deletes VLAN IDs to the port profiles.
				•	All — Indicates that the port profile allows all VLAN IDs.
				•	None — Indicates that the port profile does not allow any VLAN
				•	IDs.
					All Except <VLAN IDs> — Indicates that the port profile allows
				•	any packet except the VLAN IDs specified.
					<VLAN IDs> — Indicates that the port profile allows any packet
					with the VLAN IDs specified.
			NOTE: GVLAN supported Trunk Mode supports the Trunk VLAN and the
					Native Trunk classifications with the cTag information.
		Native VLAN/VLAN	Displays one of the following based on the VLAN configuration:
			• Access Mode — Displays the associated MAC address or MAC group
			•	or both to a VLAN ID.
				Trunk Mode — Displays the cTag for a VLAN ID or Native VLAN ID or
				both.
		Associated Domain	Lists the domain names associated with the port profile.
		QoS tab — DCB mode
		Mode	The mode of Quality of Service (QoS) assigned to the port (DCB).
		DCB Map	The DCB map name.
		Precedence	This number determines the map’s priority. Valid values are from 1
			through 100.
		Fabric Remap Priority	The fabric remap priority of the port. Valid values are CoS 0 through CoS
			6, and the default is CoS 0.
		Lossless Remap Priority	The FCoE lossless remap priority of the port. Valid values are CoS 0
			through CoS 6, and the default is CoS 0.
		QoS tab — Non-DCB mode (Ethernet PFC with Trust)
		Mode	The mode of Quality of Service (QoS) assigned to the port (non-DCB).
		Trust	Indicates whether the Ethernet trust of the port is enabled or disabled.
		Flow Control	The Ethernet priority flow control mode of the port. Possible modes are
			as follows:
			•	Off (the default)
			•	802.3x pause
			•	Tx On or Off
			•	Rx On or Off
			•	Priority Flow Control. For this mode, the Tx and Rx values for each
				CoS display in the table.
		Maps	Displays details about the following DCB maps:
			• CoS to CoS — Displays the details of the CoS to CoS map assigned
			•	to the port.
				Traffic Class — Displays the details of the Traffic Class map

assigned to the port.

NOTE: The CoS to CoS map is the default.

1322	Brocade Network Advisor IP User Manual
	53-1003056-01