Brocade Communications Systems IP250 user manual Configuring a one-time deployment schedule

17 Policy-based routing

7.Click OK on the Schedule Properties dialog box.

8.Click the Snapshot Use check box and click the ellipsis button to select the product monitoring template.

NOTE

The Snapshot Use check box is only available for IronWare products. The Pre-Post Snapshot Properties dialog box displays.

9.Select the product monitoring template you want to use from the CLI Template list.

10.Select one or more of the following to capture snapshots:

•Select the Pre-deploymentcheck box to capture a snapshot of the product’s configuration prior to deployment of the security configuration.

•Select the Post-deploymentcheck box to capture a snapshot of the product’s configuration after deployment of the security configuration.

If you select the Post-deploymentcheck box, enter the amount of time (between 1 and 300 seconds) you want the application to wait before capturing the snapshot in the Delay field.

11.Select one or more products to which you want to deploy the configuration in the Available Targets list and click the right arrow button to move them to the Selected Targets list.

12.Click OK on the Deploy to Products - PBR dialog box.

Configuring a one-time deployment schedule

To configure a one-time schedule, complete the following steps.

1.Select One Time from the Frequency list.

2.Select the time of day you want deployment to run from the Time (hh:mm) lists.

Where the hour value is from 1 through 12, the minute value is from 00 through 59, and the day or night value is AM or PM.

3.Click the Date list to select a date from the calendar.

To finish configuring the deployment schedule, return to one of the following procedures:

To finish configuring the deployment schedule, return to step 7 of “Scheduling a PBR policy deployment” on page 555.

Configuring an hourly deployment schedule

To configure an hourly schedule, complete the following steps.

1.Select Hourly from the Frequency list.

2.Select the minute past the hour you want deployment to run from the Minutes past the hour list.

Where the minute value is from 00 through 59.

To finish configuring the deployment schedule, return to step 7 of “Scheduling a PBR policy deployment” on page 555.

556	Brocade Network Advisor IP User Manual
	53-1003056-01