Brocade Communications Systems IP250 user manual Creating a network

Layer 3 access control list policy 18

1. Click the Networks tab.

FIGURE 223 Network dialog box, Networks tab

2.Review the List of Networks table:

•Name — The user-defined network name.

•Subnet — The IP address of the subnet.

•Mask — The IP address of the mask.

3.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

Creating a network

You can access the Network dialog box when configuring a standard or extended L3 ACL device configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

•“Creating a standard L3 ACL configuration” on page 581

•“Editing a standard L3 ACL configuration” on page 584

•“Copying a standard L3 ACL configuration” on page 585

•“Creating an extended L3 ACL configuration” on page 585

•“Editing an extended L3 ACL configuration” on page 587

•“Copying an extended L3 ACL configuration” on page 588

To create a network, complete the following steps.

1.Click the Networks tab.

2.Click Add.

The Add Network dialog box displays.

FIGURE 224 Add Network dialog box

Brocade Network Advisor IP User Manual	603
53-1003056-01