Brocade Communications Systems IP250 user manual Duplicating a configuration rule

Configuration rules 36

9.To change the logical operator separator, select AND or OR from the AND/OR column.

Valid values include AND and OR. The first item in a rule and the first connector in a block display empty fields. Each condition or block you add displays with an AND connector (except the first item) in the list of conditions or blocks. If you add one or more conditions to a block, each condition displays with an OR connector (except the first condition) in the block.

Fields containing a green triangle ( ) in the lower right corner are editable.

10.To group a set of conditions and blocks, enter an open parenthesis in the ( column of the condition or block where you want to start a grouping and enter a close parenthesis in the ) column after the last condition or block you want to include in the group.

You can create up to three groups. You can nest groups. To ungroup a group, clear the ( and ) columns that delineate the group.

11.To move a condition or block up in the rule, select one condition or block (except the first item) and click Move Up.

You can only move one item (condition or entire block) up at a time. If you move a condition to the first position in the rule or in a block, the logical operator (AND/OR column) is cleared. You can move a condition into a block by moving it between the start and end of a block. If the condition is already part of the block, it skips the block and moves above the block.

12.To move a condition or block down in the rule, select one condition or block (except the last item) and click Move Down.

You can only move one item (condition or entire block) down at a time. If you move a condition from the first position in the rule or in a block, the logical operator (AND/OR column) is automatically populated. You can move a condition into a block by moving it between the start and end of a block. If the condition is already part of the block, it skips the block and moves below the block.

13.To find a condition or block in the Selected Conditions/Blocks list, select a condition or block in the Library list and click Find > (right arrow).

The condition or block is highlighted in the Selected Conditions/Blocks list.

14.To find a condition or block in the Library list, select a condition or block in the Selected Conditions/Blocks list and click Find < (left arrow).

The condition or block is highlighted in the Library list.

15.To remove a condition or block from a rule, select one or more conditions and blocks in the Selected Conditions/Blocks list and click the left arrow button.

16.Click OK on the Add Configuration Rule dialog box.

17.Click OK on the Add Monitor dialog box.

The updated policy monitor displays in the Monitors table of the Policy Monitor dialog box.

18.Click Close on the Policy Monitor dialog box.

Duplicating a configuration rule

You can create a new configuration rule based on a predefined or user-defined configuration rule.

Brocade Network Advisor IP User Manual	1121
53-1003056-01