Brocade Communications Systems IP250 user manual Adding or editing a Vpls instance

28 VPLS Manager

•PE Products table — Displays the following information:

PE Devices — Names and IP addresses of the endpoint devices.

Peers Up — The number of peers that are up.

Endpoints Up — The number of endpoints that are up.

•Endpoints table — Displays the following information:

Endpoints — Names and IP addresses of the endpoint devices.

Tag Mode — Tagged if a VLAN tag is used. Untagged if a VLAN tag is not used.

Outer VLAN ID — Present if the Tag Mode for the endpoint is Tagged. The service provider end point tag.

Inner VLAN ID — Present if the Tag Mode for the endpoint is Tagged. The customer end point tag.

L2 Status — Displays whether L2 is up or down.

5.Right-click any entry in the table to display the Print pop up menu. Select Print from the menu to print the table.

6.Click Close to close the VPLS Manager dialog box.

Adding or editing a VPLS instance

To add a VPLS Instance, do the following.

1.From the Saved Configurations tab of the VPLS Manager, click the Add button.

The Target Selector dialog box of the VPLS configuration wizard displays (Figure 363).

FIGURE 363 VPLS Configuration wizard Target Selector dialog box

2.Enter a name for the VPLS. The name must be unique on each device and cannot contain spaces, asterisks (*), or question marks (?).

3.If you want to use a specific VCID, enter the VCID. If you do not specify a VCID, the next available VCID in the VCID pool is assigned.

888	Brocade Network Advisor IP User Manual
	53-1003056-01