Brocade Communications Systems IP250 Network group configuration, Viewing existing network groups

18 Layer 3 access control list policy

3.Click Yes on the confirmation message.

4.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

Network group configuration

The Management application allows you to filter traffic from a specific network group. A network group is made up of one or more devices, networks, or network groups. Use the following procedures to configure a network:

•“Viewing existing network groups” on page 606

•“Creating a network group” on page 607

•“Editing a network group” on page 608

•“Copying a network group” on page 609

•“Deleting a network group” on page 611

Viewing existing network groups

You can access the Network dialog box when configuring a standard or extended L3 ACL device configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

•“Creating a standard L3 ACL configuration” on page 581

•“Editing a standard L3 ACL configuration” on page 584

•“Copying a standard L3 ACL configuration” on page 585

•“Creating an extended L3 ACL configuration” on page 585

•“Editing an extended L3 ACL configuration” on page 587

•“Copying an extended L3 ACL configuration” on page 588

To view all existing network groups, complete the following steps. 1. Click the Network Group tab.

FIGURE 225 Network dialog box, Network Group tab

606	Brocade Network Advisor IP User Manual
	53-1003056-01