Brocade Communications Systems IP250 user manual Editing a network group

18 Layer 3 access control list policy

4.To add a host to the network group, complete the following steps.

a.Enter a valid host name in the Host Name field.

b.Click the right arrow button to move the host name to the Selected table.

5.To add an address range to the network group, complete the following steps.

a.Enter an IP address for the start of the range in the Start field.

b.Enter an IP address for the end of the range in the End field.

c.Click the right arrow button to move the address range to the Selected table.

6.To add a network to the network group, complete the following steps.

a.Select one or more networks from the Networks table.

b.Click the right arrow button to move to the Selected table.

7.To add another network group to the network group, complete the following steps.

a.Select one or more network groups from the Network Groups table.

b.Click the right arrow button to move to the Selected table.

8.Click OK on the Add Network Group dialog box.

The Network dialog box - Network Groups tab displays with the new network group in the List of Network Groups table.

9.Click Close on the Network dialog box.

To finish configuring the ACL, return to one of the above procedures.

Editing a network group

You can access the Network dialog box when configuring a standard or extended L3 ACL device configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:

•“Creating a standard L3 ACL configuration” on page 581

•“Editing a standard L3 ACL configuration” on page 584

•“Copying a standard L3 ACL configuration” on page 585

•“Creating an extended L3 ACL configuration” on page 585

•“Editing an extended L3 ACL configuration” on page 587

•“Copying an extended L3 ACL configuration” on page 588

To edit a network group, complete the following steps.

1.Click the Network Groups tab.

2.Select the network group you want to edit in the List of Network Groups table and click Edit. The Edit Network Group dialog box displays.

3.To remove a component from the network group, select the component in the Selected table and click the left arrow button.

4.To add a host to the network group, complete the following steps.

a.Enter a valid host name in the Host Name field.

b.Click the right arrow button to move the host name to the Selected table.

608	Brocade Network Advisor IP User Manual
	53-1003056-01