Brocade Communications Systems IP250 user manual Click the SNMPv3 Read/Write tab

3 Individual IP device discovery

2.Select one or more IP devices you want to edit in the Discovered Products table.

Select multiple devices by holding down the CTRL key and clicking more than one device.

NOTE

You cannot edit IronWare and Network OS devices at the same time.

NOTE

You can only edit multiple Network OS devices that are running the same firmware level.

3.Click Edit.

The Edit product dialog box displays.

4.Select one of the following options:

•Try only configured Discovery SNMP settings — Select to use the SNMP settings configured in the Global Settings tab to contact the device.

•Also try these settings — Select to use specific SNMP settings to contact the device. If you do not enter SNMP settings or if the settings do not authenticate on the device, the application uses the SNMP settings configured in the Global Settings tab to contact the device.

NOTE

You can configure both SNMPv3 and SNMPv1/SNMPv2c credentials at the same time; however, discovery tries the SNMPv3 credentials before trying the SNMPv1 and SNMPv2c credentials.

5.Change the SNMPv3 read-write credentials by completing the following steps.

NOTE

These credentials are not applicable for DCB devices.

a.Click the SNMPv3 Read/Write tab.

FIGURE 39 SNMPv3 credentials

b.Enter the SNMPv3 user name in the User ID field.

The user name can be from 1 through 16 characters long, case sensitive, and allows all printable ASCII characters.

c.Select one of the following protocols from the Authentication Protocol list:

• None

88	Brocade Network Advisor IP User Manual
	53-1003056-01