Brocade Communications Systems IP250 user manual Copying a monitoring configuration

25 Monitoring configurations

11.Click OK.

The Deployment Status dialog box displays, which allows you to view the progress and status of the deployment.

Click Abort to stop the deployment.

NOTE

The abort action does not stop the tasks that have already started.

When deployment is complete, click Report to view the CLI Deployments Report.

12.Click Close to close the Deployment Status dialog box.

NOTE

Closing the Deployment Status dialog box does not stop deployment.

To check the results of the deployment in the Product CLI Report, refer to “CLI deployment reports” on page 802. For details about valid and invalid responses when you deploy a configuration, refer to “Valid and invalid responses from devices” on page 790.

Copying a monitoring configuration

To copy an existing monitoring configuration to create a new one, complete the following steps.

1.Select Configure > CLI Configuration. The CLI Configuration dialog box displays.

2.Click the Monitoring tab.

3.Select the configuration you want to copy in the Monitoring table and click Duplicate. The CLI Monitoring Template dialog box displays.

4.Complete step 3 through step 4 from the “Creating a new product configuration” on page 779.

5.Review your entries on all the template tabs and choose one of the following options:

•Click OK to save the configuration and add it to the list of configurations on the Monitoring tab. The new definition can be added to a configuration payload in the Configuration Wizard and deployed later.

To test the configuration, refer to “Testing a configuration” on page 789.

•Click Deploy to deploy the configuration to the selected targets. Click Yes on the confirmation message.

If you selected the Prompt for additional targets during manual deployment check box, the Target tab of the Deployment of Configuration_Name dialog box displays. Continue with step 6.

If the configuration contains parameters that must be defined, the Deployment of Configuration_Name dialog box displays with a list of all parameters in the deployment. Go to step 7.

6.Define additional targets for the deployment (refer to step 4), as needed.

7.Edit the mode and the parameter values (refer to step 6), as needed.

800	Brocade Network Advisor IP User Manual
	53-1003056-01