5 Software Configuration

Large : 1024 MB

For all 64-bit servers, the default minimum Server Heap Size for all network sizes is 2048 MB.

NOTE

There is no restriction on the maximum value for Server Heap Size in a 64-Bit Server. The correct server heap size value must be given according to the RAM present in the server.

6.Click Apply or OK to save your work.

NOTE

Changes to this option take effect after an application restart.

NOTE

You can only restart the server using the Server Management Console (Start > Programs > Management_Application_Name 12.X.X > Server Management Console).

7.Click OK on the “changes take effect after application restart” message.

Configuring asset polling

NOTE

Asset polling is only applicable for Fabric OS DCB products discovered from the IP tab.

Asset polling allows you set the length of time between state change polling. To maximize the efficiency of the polling feature (balance the amount of possible information with any possible performance impact), base your settings on the size of the SAN.

To configure asset polling, complete the following steps.

1.Select Server > Options.

The Options dialog box displays.

2.Select Memory Allocation in the Category list to set the memory allocation for the server and client.

The Memory Allocation pane displays (Figure 68).

3.Enter how often you want to check for state changes in the Check for state change every field.

Valid values are from 1 through 600 seconds. You cannot enter a value lower than the default minimum value.

Default minimum values are as follows:

Small (Professional): 60 seconds

Medium: 120 seconds

Large: 180 seconds

4.Enter how often you want to check for state changes in the If no state change, Poll switch every field.

Valid values are from 1 through 3,600 seconds. Default values are as follows:

Small (Professional): 120 seconds

Medium: 900 seconds

168

Brocade Network Advisor IP User Manual

 

53-1003056-01

Page 220
Image 220
Brocade Communications Systems IP250 user manual Configuring asset polling