Agilent Technologies 5000 Series manual MEASureVTOP

3Commands by Subsystem

:MEASure:VTOP

(see page 530)

Command Syntax :MEASure:VTOP [<source>]

<source> ::= {CHANnel<n> FUNCtion MATH}

<n> ::= {1 2 3 4} for the four channel oscilloscope models <n> ::= {1 2} for the two channel oscilloscope models

The :MEASure:VTOP command installs a screen measurement and starts a waveform top value measurement.

N O T E This query is not available if the source is FFT (Fast Fourier Transform).

Query Syntax :MEASure:VTOP? [<source>]

The :MEASure:VTOP? query returns the vertical value at the top of the waveform. The top value of the pulse is normally not the same as the maximum value.

Return Format <value><NL>

<value> ::= vertical value at the top of the waveform in NR3 format

See Also • "Introduction to :MEASure Commands" on page 218

•":MEASure:SOURce" on page 240

•":MEASure:VMAX" on page 249

•":MEASure:VAMPlitude" on page 246

•":MEASure:VBASe" on page 248

254 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference