Agilent Technologies 5000 Series manual CHANnelnUNITs, Return Format unitsNL

Commands by Subsystem 3

:CHANnel<n>:UNITs

(see page 530)

Command Syntax :CHANnel<n>:UNITs <units> <units> ::= {VOLT AMPere}

<n> ::= {1 2} for the two channel oscilloscope models

<n> ::= {1 2 3 4} for the four channel oscilloscope models

The :CHANnel<n>:UNITs command sets the measurement units for the connected probe. Select VOLT for a voltage probe and select AMPere for a current probe. Measurement results, channel sensitivity, and trigger level will reflect the measurement units you select.

Query Syntax :CHANnel<n>:UNITs?

The :CHANnel<n>:UNITs? query returns the current units setting for the specified channel.

Return Format <units><NL>

<units> ::= {VOLT AMP}

See Also • "Introduction to :CHANnel<n> Commands" on page 143

•":CHANnel<n>:RANGe" on page 157

•":CHANnel<n>:PROBe" on page 152

•":EXTernal:UNITs" on page 180

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 159