Agilent Technologies 5000 Series manual MARKerX1Y1source

Commands by Subsystem 3

:MARKer:X1Y1source

(see page 530)

Command Syntax :MARKer:X1Y1source <source>

<source> ::= {CHANnel<n> FUNCtion MATH}

<n> ::= {1 2 3 4} for the four channel oscilloscope models <n> ::= {1 2} for the two channel oscilloscope models

	The :MARKer:X1Y1source command sets the source for the cursors. The
	channel you specify must be enabled for cursors to be displayed. If the
	channel or function is not on, an error message is issued. Sending a
	:MARKer:X1Y1source command will put the cursors in the MANual mode
	(see ":MARKer:MODE" on page 205).
	This product does not allow independent settings of the X1Y1 and X2Y2
	marker sources. Setting the source for one pair of markers sets the source
	for the other. If :MARKer:MODE is set to OFF or MANual, setting
	:MEASure:SOURce to CHANnel<n>, FUNCtion, or MATH will also set
	:MARKer:X1Y1source and :MARKer:X2Y2source to this value.
	MATH is an alias for FUNCtion. The query will return FUNC if the source is FUNCtion or
N O T E
	MATH.
Query Syntax	:MARKer:X1Y1source?
	The :MARKer:X1Y1source? query returns the current source for the
	cursors. If all channels are off or if :MARKer:MODE is set to OFF, the
	query returns NONE.
Return Format	<source><NL>
	<source> ::= {CHAN<n> FUNC NONE}
See Also	• "Introduction to :MARKer Commands" on page 204
	• ":MARKer:MODE" on page 205
	• ":MARKer:X2Y2source" on page 209
	• ":MEASure:SOURce" on page 240

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 207