Commands by Subsystem 3

:TRIGger Commands

Control the trigger modes and parameters for each trigger type. See:

"Introduction to :TRIGger Commands" on page 313

"General :TRIGger Commands" on page 316

":TRIGger:CAN Commands" on page 324

":TRIGger:DURation Commands" on page 335

":TRIGger[:EDGE] Commands" on page 341

":TRIGger:GLITch Commands" on page 347 (Pulse Width trigger)

":TRIGger:IIC Commands" on page 355

":TRIGger:LIN Commands" on page 364

":TRIGger:SPI Commands" on page 372

":TRIGger:TV Commands" on page 381

":TRIGger:UART Commands" on page 387

Introduction to The commands in the TRIGger subsystem define the conditions for an :TRIGger internal trigger. Many of these commands are valid in multiple trigger

Commands modes.

The default trigger mode is :EDGE.

The trigger subsystem controls the trigger sweep mode and the trigger specification. The trigger sweep (see ":TRIGger:SWEep" on page 323) can be AUTO or NORMal.

NORMal mode displays a waveform only if a trigger signal is present and the trigger conditions are met. Otherwise the oscilloscope does not trigger and the display is not updated. This mode is useful for

low- repetitive- rate signals.

AUTO trigger mode generates an artificial trigger event if the trigger specification is not satisfied within a preset time, acquires unsynchronized data and displays it.

AUTO mode is useful for signals other than low- repetitive- rate signals. You must use this mode to display a DC signal because there are no edges on which to trigger.

The following trigger types are available (see ":TRIGger:MODE" on page 319).

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference

313

Page 313
Image 313
Agilent Technologies 5000 Series manual TRIGger Commands, Commands modes