Agilent Technologies 5000 Series manual MARKerX1Position, Introduction to MARKer Commands on

3Commands by Subsystem

:MARKer:X1Position

	(see page 530)
Command Syntax	:MARKer:X1Position <position> [suffix]
	<position> ::= X1 cursor position in NR3 format
	<suffix> ::= {s ms us ns ps Hz kHz MHz}
	The :MARKer:X1Position command sets :MARKer:MODE to MANual, sets
	the X1 cursor position and moves the X1 cursor to the specified value.
Query Syntax	:MARKer:X1Position?
	The :MARKer:X1Position? query returns the current X1 cursor position. If
	the front- panel cursors are off an error is returned. This is functionally
	equivalent to the obsolete :MEASure:TSTArt command/query.
Return Format	<position><NL>
	<position> ::= X1 cursor position in NR3 format
See Also	• "Introduction to :MARKer Commands" on page 204
	• ":MARKer:MODE" on page 205
	• ":MARKer:X2Position" on page 208
	• ":MARKer:X1Y1source" on page 207
	• ":MARKer:X2Y2source" on page 209
	• ":MEASure:TSTArt" on page 484

206 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference