Agilent Technologies 5000 Series manual RECall Commands Summary

Commands by Subsystem 3

:RECall Commands

Recall previously saved oscilloscope setups and traces. See "Introduction to :RECall Commands" on page 257.

Table 51 :RECall Commands Summary

Command	Query	Options and Query Returns
:RECall:FILename	:RECall:FILename?	<base_name> ::= quoted ASCII
<base_name> (see	(see page 258)	string
page 258)
:RECall:IMAGe[:STARt]	n/a	<file_spec> ::= {<internal_loc>
[<file_spec>] (see		<file_name>}
page 259)		<internal_loc> ::= 0-9; an
		integer in NR1 format
		<file_name> ::= quoted ASCII
		string
n/a	:RECall:PWD? (see	<path_info> ::= quoted ASCII
	page 260)	string
:RECall:SETup[:STARt]	n/a	<file_spec> ::= {<internal_loc>
[<file_spec>] (see		<file_name>}
page 261)		<internal_loc> ::= 0-9; an
		integer in NR1 format
		<file_name> ::= quoted ASCII
		string

Introduction to The :RECall subsystem provides commands to recall previously saved :RECall oscilloscope setups and traces.

Commands

Reporting the Setup

Use :RECall? to query setup information for the RECall subsystem.

Return Format

The following is a sample response from the :RECall? query. In this case, the query was issued following the *RST command.

:REC:FIL "scope_0"

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 257