Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 397

:TRIGger:UART:SOURce:RX

(see page 530)
Command Syntax :TRIGger:UART:SOURce:RX <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :TRIGger:UART:SOURce:RX command controls which signal is used as
the Rx source by the serial decoder and/or trigger when in UART mode.
Query Syntax :TRIGger:UART:SOURce:RX?
The :TRIGger:UART:SOURce:RX? query returns the current source for the
UART Rx signal.
Return Format <source><NL>
See Also "Introduction to :TRIGger Commands" on page 313
":TRIGger:MODE" on page 319
":TRIGger:UART:TYPE" on page 399
":TRIGger:UART:BITorder" on page 390