Agilent Technologies 5000 Series manual MEASureVSTArt, MARKerX1Y1source on

5Obsolete and Discontinued Commands

:MEASure:VSTArt

	(see page 530)
Command Syntax	:MEASure:VSTArt <vstart_argument>
	<vstart_argument> ::= value for vertical marker 1
	The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to
	the specified value corresponding to the selected source. The source can
	be selected by the MARKer:X1Y1source command.
	The short form of this command, VSTA, does not follow the defined Long Form to Short
N O T E
	Form Truncation Rules (see page 532). The normal short form, VST, would be the same for
	both VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.
	The :MEASure:VSTArt command is an obsolete command provided for compatibility to
N O T E
	previous oscilloscopes. Use the :MARKer:Y1Position command (see page 211) instead.
Query Syntax	:MEASure:VSTArt?
	The :MEASure:VSTArt? query returns the current value of the Y1 cursor.
Return Format	<value><NL>
	<value> ::= voltage at voltage marker 1 in NR3 format
See Also	• "Introduction to :MARKer Commands" on page 204
	• "Introduction to :MEASure Commands" on page 218
	• ":MARKer:Y1Position" on page 211
	• ":MARKer:Y2Position" on page 212
	• ":MARKer:YDELta" on page 213
	• ":MARKer:X1Y1source" on page 207
	• ":MEASure:SOURce" on page 240
	• ":MEASure:TDELta" on page 480
	• ":MEASure:TSTArt" on page 484

490 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference