Agilent Technologies 5000 Series manual TRIGgerUARTSOURceTX

3Commands by Subsystem

:TRIGger:UART:SOURce:TX

(see page 530)

Command Syntax :TRIGger:UART:SOURce:TX <source>

<source> ::= {CHANnel<n> EXTernal} for the DSO models

<source> ::= {CHANnel<n> DIGital0,..,DIGital15} for the MSO models <n> ::= {1 2 3 4} for the four channel oscilloscope models <n> ::= {1 2} for the two channel oscilloscope models

	The :TRIGger:UART:SOURce:TX command controls which signal is used as
	the Tx source by the serial decoder and/or trigger when in UART mode.
Query Syntax	:TRIGger:UART:SOURce:TX?
	The :TRIGger:UART:SOURce:TX? query returns the current source for the
	UART Tx signal.
Return Format	<source><NL>
See Also	• "Introduction to :TRIGger Commands" on page 313
	• ":TRIGger:MODE" on page 319
	• ":TRIGger:UART:TYPE" on page 399
	• ":TRIGger:UART:BITorder" on page 390

398 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference