Agilent Technologies 5000 Series manual TRIGgerCANSIGNalDEFinition, Command Syntax

5Obsolete and Discontinued Commands

:TRIGger:CAN:SIGNal:DEFinition

Command Syntax

N O T E

(see page 530)

:TRIGger:CAN:SIGNal:DEFinition <value>

<value> ::= {CANH CANL RX TX DIFFerential}

The :TRIGger:CAN:SIGNal:DEFinition command sets the CAN signal type when :TRIGger:CAN:TRIGger is set to SOF (start of frame). These signals can be set to:

Dominant high signal:

•CANH — the actual CAN_H differential bus signal.

Dominant low signals:

•CANL — the actual CAN_L differential bus signal.

•RX — the Receive signal from the CAN bus transceiver.

•TX — the Transmit signal to the CAN bus transceiver.

•DIFFerential — the CAN differential bus signal connected to an analog source channel using a differential probe.

With InfiniiVision 5000 Series oscilloscope software version 5.00 or greater, this command is available, but the only legal value is DIFF.

Query Syntax	:TRIGger:CAN:SIGNal:DEFinition?
	The :TRIGger:CAN:SIGNal:DEFinition? query returns the current CAN
	signal type.
Return Format	<value><NL>
	<value> ::= DIFF
See Also	• "Introduction to :TRIGger Commands" on page 313
	• ":TRIGger:MODE" on page 319
	• ":TRIGger:CAN:SIGNal:BAUDrate" on page 331
	• ":TRIGger:CAN:SOURce" on page 332
	• ":TRIGger:CAN:TRIGger" on page 333

496 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference