Agilent Technologies 5000 Series manual WAVeformSOURceSUBSource, See

3Commands by Subsystem

:WAVeform:SOURce:SUBSource

(see page 530)

Command Syntax :WAVeform:SOURce:SUBSource <subsource>

<subsource> ::= {{NONE RX} TX}

If the :WAVeform:SOURce is SBUS (serial decode), more than one data set may be available, and this command lets you choose from the available data sets.

Currently, only UART serial decode lets you get "TX" data. The default, NONE, specifies "RX" data. (RX is an alias for NONE.)

If the :WAVeform:SOURce is not SBUS, or the :SBUS:MODE is not UART, the only valid subsource is NONE.

Query Syntax :WAVeform:SOURce:SUBSource?

The :WAVeform:SOURce:SUBSource? query returns the current waveform subsource setting.

Return Format <subsource><NL>

<subsource> ::= {NONE TX}

See Also • "Introduction to :WAVeform Commands" on page 403

•":WAVeform:SOURce" on page 420

424 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference