Agilent Technologies 5000 Series :SBUS:MODE

286 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
3Commands by Subsystem
:SBUS:MODE
(see page 530)
Command Syntax :SBUS:MODE <mode>
<mode> ::= {IIC | SPI | CAN | LIN | UART}
The :SBUS:MODE command determines the decode mode for the serial
bus.
Query Syntax :SBUS:MODE?
The :SBUS:MODE? query returns the current serial bus decode mode
setting.
Return Format <mode><NL>
<mode> ::= {IIC | SPI | CAN | LIN | UART | NONE}
Errors •"- 241, Hardware missing" on page 501
See Also •"Introduction to :SBUS Commands" on page 277
•":TRIGger:MODE" on page 319
•":TRIGger:IIC Commands" on page 355
•":TRIGger:SPI Commands" on page 372
•":TRIGger:CAN Commands" on page 324
•":TRIGger:LIN Commands" on page 364
•":TRIGger:UART Commands" on page 387
NOTE This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
option has been licensed.