Agilent Technologies 5000 Series manual HWEenable Hardware Event Enable Register

3Commands by Subsystem

:HWEenable (Hardware Event Enable Register)

(see page 530)

Command Syntax :HWEenable <mask>

<mask> ::= 16-bit integer

The :HWEenable command sets a mask in the Hardware Event Enable register. Set any of the following bits to "1" to enable bit 12 in the Operation Status Condition Register and potentially cause an SRQ (Service Request interrupt to be generated.

3//

/RFNHG



3//

/RFNHG

              

25

7R+:(ELWLQ

2SHUDWLRQ6WDWXV &RQGLWLRQ5HJLVWHU

+:(5HJLVWHU&21'LWLRQ" +DUGZDUH(YHQW&RQGLWLRQ5HJLVWHU

+:(5HJLVWHU>(9(1W@" +DUGZDUH(YHQW(YHQW5HJLVWHU



+:(HQDEOH+:(HQDEOH"

+DUGZDUH(YHQW(QDEOH0DVN5HJLVWHU

Table 34 Hardware Event Enable Register (HWEenable)

Bit	Name	Description	When Set (1 = High = True), Enables:
15-13	---	---	(Not used.)
12	PLL	PLL Locked	This bit is for internal use and is not intended
	Locked		for general use.
11-0	---	---	(Not used.)

Query Syntax	:HWEenable?
	The :HWEenable? query returns the current value contained in the
	Hardware Event Enable register as an integer number.
Return Format	<value><NL>
	<value> ::= integer in NR1 format.
See Also	• "Introduction to Root (:) Commands" on page 88

98 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference