Agilent Technologies 5000 Series manual TIMebase Commands Summary

3Commands by Subsystem

:TIMebase Commands

Control all horizontal sweep functions. See "Introduction to :TIMebase Commands" on page 302.

Table 55 :TIMebase Commands Summary

Command	Query	Options and Query Returns
:TIMebase:MODE	:TIMebase:MODE? (see	<value> ::= {MAIN WINDow XY
<value> (see	page 304)	ROLL}
page 304)
:TIMebase:POSition	:TIMebase:POSition?	<pos> ::= time from the trigger
<pos> (see page 305)	(see page 305)	event to the display reference
		point in NR3 format
:TIMebase:RANGe	:TIMebase:RANGe? (see	<range_value> ::= 10 ns through
<range_value> (see	page 306)	500 s in NR3 format
page 306)
:TIMebase:REFerence	:TIMebase:REFerence?	<return_value> ::= {LEFT CENTer
{LEFT CENTer	(see page 307)	RIGHt}
RIGHt} (see page 307)
:TIMebase:SCALe	:TIMebase:SCALe? (see	<scale_value> ::= scale value in
<scale_value> (see	page 308)	seconds in NR3 format
page 308)
:TIMebase:VERNier {{0	:TIMebase:VERNier?	{0 1}
OFF} {1 ON}}	(see page 309)
(see page 309)
:TIMebase:WINDow:POSi	:TIMebase:WINDow:POSi	<pos> ::= time from the trigger
tion <pos> (see	tion? (see page 310)	event to the delayed view
page 310)		reference point in NR3 format
:TIMebase:WINDow:RANG	:TIMebase:WINDow:RANG	<range value> ::= range value in
e <range_value> (see	e? (see page 311)	seconds in NR3 format for the
page 311)		delayed window
:TIMebase:WINDow:SCAL	:TIMebase:WINDow:SCAL	<scale_value> ::= scale value in
e <scale_value> (see	e? (see page 312)	seconds in NR3 format for the
page 312)		delayed window

Introduction to The TIMebase subsystem commands control the horizontal (X- axis) :TIMebase functions and set the oscilloscope to X- Y mode (where channel 1 becomes Commands the X input and channel 2 becomes the Y input). The time per division,

delay, vernier control, and reference can be controlled for the main and window (delayed) time bases.

Reporting the Setup

302 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference