Agilent Technologies 5000 Series manual 305 or

Obsolete and Discontinued Commands 5

Obsolete Command	Current Command Equivalent	Behavior Differences
:MEASure:TMIN (see	:MEASure:XMIN (see
page 483)	page 256)
:MEASure:TSTArt (see	:MARKer:X1Position (see
page 484)	page 206)
:MEASure:TSTOp (see	:MARKer:X2Position (see
page 485)	page 208)
:MEASure:TVOLt (see	:MEASure:TVALue (see	TVALue measures additional
page 486)	page 244)	values such as db, Vs, etc.
:MEASure:UPPer (see	:MEASure:DEFine:THResholds	MEASure:DEFine:THResholds
page 488)	(see page 222)	can define absolute values or
		percentage
:MEASure:VDELta (see	:MARKer:YDELta (see
page 489)	page 213)
:MEASure:VSTArt (see	:MARKer:Y1Position (see
page 490)	page 211)
:MEASure:VSTOp (see	:MARKer:Y2Position (see
page 491)	page 212)
:PRINt? (see page 492)	:DISPlay:DATA? (see
	page 164)
:TIMebase:DELay (see	:TIMebase:POSition (see	TIMebase:POSition is position
page 494)	page 305) or	value of main time base;
	:TIMebase:WINDow:POSition	TIMebase:WINDow:POSition
	(see page 310)	is position value of delayed
		time base window.
:TRIGger:CAN:ACKNowledge	none
(see page 495)
:TRIGger:CAN:SIGNal:DEFiniti	none
on (see page 496)
:TRIGger:LIN:SIGNal:DEFinitio	none
n (see page 497)
:TRIGger:TV:TVMode (see	:TRIGger:TV:MODE (see
page 498)	page 383)

Discontinued Discontinued commands are commands that were used by previous Commands oscilloscopes, but are not supported by the InfiniiVision 5000 Series oscilloscopes. Listed below are the Discontinued commands and the

nearest equivalent command available (if any).

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 459