Agilent Technologies 5000 Series manual MEASure Commands Summary

3Commands by Subsystem

:MEASure Commands

Select automatic measurements to be made and control time markers. See "Introduction to :MEASure Commands" on page 218.

Table 50 :MEASure Commands Summary

Command	Query	Options and Query Returns
:MEASure:CLEar (see	n/a	n/a
page 220)
:MEASure:COUNter	:MEASure:COUNter?	<source> ::= {CHANnel<n>}
[<source>] (see	[<source>] (see	<n> ::= 1-2 or 1-4 in NR1 format
page 221)	page 221)	<return_value> ::= counter
		frequency in Hertz in NR3 format
:MEASure:DEFine	:MEASure:DEFine?	<delay spec> ::=
DELay, <delay spec>	DELay (see page 223)	<edge_spec1>,<edge_spec2>
(see page 222)		edge_spec1 ::=
		[<slope>]<occurrence>
		edge_spec2 ::=
		[<slope>]<occurrence>
		<slope> ::= {+ -}
		<occurrence> ::= integer
:MEASure:DEFine	:MEASure:DEFine?	<threshold spec> ::= {STANdard}
THResholds,	THResholds (see	{<threshold mode>,<upper>,
<threshold spec> (see	page 223)	<middle>,<lower>}
page 222)		<threshold mode> ::= {PERCent
		ABSolute}
:MEASure:DELay	:MEASure:DELay?	<source1,2> ::= {CHANnel<n>
[<source1>]	[<source1>]	FUNCtion MATH}
[,<source2>] (see	[,<source2>] (see	<n> ::= 1-2 or 1-4 in NR1 format
page 225)	page 225)	<return_value> ::=
		floating-point number delay time
		in seconds in NR3 format
:MEASure:DUTYcycle	:MEASure:DUTYcycle?	<source> ::= {CHANnel<n>
[<source>] (see	[<source>] (see	FUNCtion MATH}
page 227)	page 227)	<n> ::= 1-2 or 1-4 in NR1 format
		<return_value> ::= ratio of
		positive pulse width to period in
		NR3 format
:MEASure:FALLtime	:MEASure:FALLtime?	<source> ::= {CHANnel<n>
[<source>] (see	[<source>] (see	FUNCtion MATH}
page 228)	page 228)	<n> ::= 1-2 or 1-4 in NR1 format
		<return_value> ::= time in
		seconds between the lower and
		upper thresholds in NR3 format

214 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference