Agilent Technologies 5000 Series manual Introduction to, Decode option has been licensed

Commands by Subsystem 3

Table 53 :SBUS Commands Summary (continued)

Command	Query	Options and Query Returns
n/a	:SBUS:UART:COUNt:TXFR	<frame_count> ::= integer in NR1
	ames? (see page 292)	format
:SBUS:UART:FRAMing	:SBUS:UART:FRAMing?	<value> ::= {OFF <decimal>
<value> (see	(see page 293)	<nondecimal>}
page 293)		<decimal> ::= 8-bit integer from
		0-255 (0x00-0xff)
		<nondecimal> ::= #Hnn where n ::=
		{0,..,9 A,..,F} for hexadecimal
		<nondecimal> ::= #Bnn...n where n
		::= {0 1} for binary

Introduction to	The :SBUS subsystem commands control the serial decode bus viewing,
:SBUS	mode, and other options.
Commands
	These commands are only valid on 4 (analog) channel oscilloscope models when a serial
N O T E
	decode option has been licensed.

Reporting the Setup

Use :SBUS? to query setup information for the :SBUS subsystem.

Return Format

The following is a sample response from the :SBUS? query. In this case, the query was issued following a *RST command.

:SBUS:DISP 0;MODE IIC

Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 277