Cisco Systems Cisco MGX 8850 - page 142

2-84
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter2 Shelf Management Commands
runrev
Note Of special note in Tabl e 2-13, runrev c au s es t he s ta ndby ca rd t o be co me t he ac tive card. The
reversed location of the “Active” and “Standby” columns shows the changed states.
After you execute runrev, the PXM45 updates the database records on disk if changes occur (such as
changes to the configuration or network topology). If you revert to the previous version by executing
abortrev, the post-runrev changes are lost. For example, if a switch w as added to the network between
runrev and abortrev, the restored database has no record of the topology change.
Cards on Which This Command Runs
PXM45
Syntax
runrev
<slot>
<revision>
Syntax Description
Related Commands
abortrev, commitrev, loadrev, setrev, dspcd, dspversion
Attributes
Table2-13 Redundant Pair Upgrade From 2.x to 2.y
Firmware
status Before upgrade After loadrev After runrev After commitrev
Active Standby Active Standby Standby Active Standby Active
Primary 2.x 2.x 2.x 2.x 2 .y 2.y 2.y 2.y
Secondary 2.x 2.x 2.y 2.y 2.x 2.x 2.y 2.y
Current 2.x 2.x 2.x 2.y 2.y 2.y 2.y 2.y
abortrev resets
only standby card. abortrev resets both cards.
slot Number of the targeted card slot.
revision Revision number derived f rom the na me of th e f i rmw are f i l e. If th e sta ndb y ca rd does no t
have the specified image, runrev has no effect, and the system displays an error message.
For an explanation, see the section, “Version Numbering Conventions,” in the loadrev
description.
Log: log State: active Privilege: SERVICE_GP