7-9
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter7 SPVC and SVC Commands addcon
Syntax
addcon <ifNum> <vpi> <vci> <service type> <mastership>
[-slave <NSAP.vpi.vci>]
[-lpcr <local PCR>]
[-rpcr <remote PCR>]
[-lscr <local SCR>]
[-rscr <remote SCR>]
[-lmbs <local MBS>]
[-rmbs <remote MBS>]
[-cdvt <local CDVT>]
[-lcdv <local maxCDV>]
[-rcdv <remote maxCDV>]
[-lctd <local maxCTD>]
[-rctd <remote maxCTD>]
[-cc <OAM CC Cnfg>]
[-stat <Stats Cnfg>]
[-frame <frame discard>]
[-mc <maximum cost>]
Syntax Description
For the applicable parameters, the “local” end is the point at which you are provisioning the connection.
ifNum The logical port number. The range for AXSM is 1–60. This ifNum corresponds
to the ifNum added through the addport command.
When adding an endpoint on a NNI port, make sure that PNNI signaling is
disabled on the PXM45 (cnfpnportsig <portid> -nniver none).
vpi Virtual path identifier value in the range 0–255 (UNI) or 0–4095 (NNI or VNNI).
For VNNI, specify one VPI per port.
vci Virtual connection identifier (VCI ) :
•For a VCC on a UNI, the range is 1–4095. On an NNI or VNNI, the VCI
range is 32–65535. For MPLS, the recommended minimum VCI is 35.
•For a VPC, the vc i is 0.