Cisco Systems Cisco MGX 8850 - page 338

5-44
Cisco MGX 8850 Routing Switch Command Reference
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Chapter5 PNNI Commands
cnfpnni-timer
-helloHolddown Specify the initial value for the Hello hold d own t im e r t h at th e node
uses to limit the rate at w h ich i t s e nd s H e llo s .
Units:100 ms. 1 = 0.1 seconds
Range: 0.1–1000
Default = 10, (1 seco nd)
-helloInterval Specify the initia l value for the Hello timer in second s. The value limits
the rate at which the node sends Hellos.
Range: 1–300 seconds.
Default = 15 second s.
-helloInactivityFactor The product of the hello-inactivity-factor and th e p e e r neighbor
hello-interval is the maximum time (in sec) that th e ne ighbor is
considered alive after the last recep tio n o f a H el lo p ack et.
Range: 1–50 seconds.
Default= 5 seconds.
-ptseRefreshInterval Specify the init ial ti m e all owed for the PTSE to re-orig in ate specified
in seconds.
Range: 30–1800 seconds.
Default= 1800 seconds.
-ptseLifetimeFactor Specify the value for the li fetime multiplier, expressed a s a percentage.
The product of it and the ptse-refresh-interval is the initial value of the
remaining lifetime of a self-created PTSE.
Range: 101–1000 per cent.
Default= 200.
-retransmitInterval Specify the period between retransmissions of unacknowledged DS,
PTSE request, and PTSP specified in seconds.
Range: 5–60 seconds.
Default= 5 seconds.
-ptseDelayedAckI nterval Specify the minimum interval between transmissions of dela yed PTSE
acknowledgment packets.
Units:100 ms. 1 = 0.1 seconds.
Range: 1–10 seconds.
Default = 10, i.e., 1 second.
-avcrPm Specify the proportional mu ltip lier use d in the alg ori thms that
determine significant change for availab le cell rate (AvCR) parameters.
avcr-pm is expressed as a per cen ta ge .
Range: 1–99 per cent.
Default= 50 per cent.